Helix P One MK2, High-Res моноблок, 1800W, клас D, made in Germany

Усилвател Helix P One MK2, High-Res моноблок, 1800W, клас D, made in Germany

Loads of power and tremendous stability: Our new P ONE MK2 is the ideal performance package for any subwoofer configuration. With up to 1,800 Watts RMS @ 1 Ohm, the upgrade to our powerful mono amplifier is going to rev up any woofer while always maintaining full control due to its enormous damping factor.

The P ONE MK2 is designed for more than just driving subwoofers. With its particularly wide frequency range up to 40 kHz and excellent signal-to-noise ratio as well as the extremely low THD, you can expect nothing less than High-Res sound quality, making it well suited for the use as a fullrange amplifier.

Due to the newly integrated optical digital input, an interference-free and ground-isolated signal transmission in the best possible quality all the way into the amplifier is now possible. The input receives signals up to a 96 kHz sampling rate lossless via light conductor and converts them back to the analog level via a cutting-edge 32-Bit BurrBrown D/A converter. Thus, the P ONE MK2 can be perfectly combined with one of our DSP amplifiers with optical digital output, for example the HELIX P SIX DSP ULTIMATE.

In terms of power density, the P ONE MK2 plays in a different league. No other HELIX amplifier includes so much power into such a compact package. This unique power-to-size ratio enabled by our extraordinary efficient Class D concept, which goes hand in hand with exceptionally low heat dissipation. Dimensions (H x W x D) 50 x 260 x 190 mm / 1.97 x 10.24 x 7.48”

Характеристики

- Class D mono amplifier with extremely high performance up to 1,800 watts RMS @ 1 ohms

- High-res capability thanks to an extensive audio frequency response up to over 40 kHz for unsurpassed sound quality

- Extremely high efficiency and low heat development with very compact dimensions

- High damping factor for maximum speaker control

- Digital, optical signal input in SPDIF format including SPDIF Direct In switch to route the digital input signal for lossless signal

- BurrBrown latest generation DA converter with 32 bit resolution

- Switchable Subsonic filter

- Controlled switching power supply with start-stop capability for extremely stable output powers even in the event of voltage drops

- SMD technology ( Surface Mounted Device ) combines minimal space requirements with maximum reliability

- Input Mode switch to adapt the amplifier to the input signal

- Can be perfectly combined with HELIX P SIX DSP ULTIMATE amplifier

Технически данни

- Power RMS ≤ 1% THD+N / @ 4 Ohms 1 x 500 Watts / @ 2 Ohms 1 x 880 Watts / @ 1 Ohm 1 x 1,500 Watts

- Max. output power per channel* Up to 1.800 Watts RMS @ 1 Ohms

- Inputs 2 x RCA / Cinch 1 x Remote In 1 x Optical SPDIF (28 - 96 kHz)

- Input sensitivity RCA / Cinch 0.5 - 8 Volts

- Input impedance RCA / Cinch - 20 kOhms

- Outputs 1 x Speaker output

- Signal converter for digital input BurrBrown 32 Bit DA converter

- Frequency response 21 Hz - 40,000 Hz

- Subsonic 21 Hz

- Slope subsonic / lowpass Butterworth 48 dB/Oct.

- Signal-to-noise ratio digital input 110 dB (A-weighted)

- Signal-to-noise ratio analog input 110 dB (A-weighted)

- Distortion (THD) < 0.01 %

- Damping factor > 450

- Operating voltage 10.5 - 17 Volts (max. 5 sec. down to 6 Volts)

- Idle current 1500 mA

- Operating temperature range -40° C to +70° C

- Fuse 4 x 30 A LP-Mini-fuse (APS)

- Power rating DC 12 V ⎓ 160 A max.

- Additional features Input mode switch, SPDIF Direct In switch, Start-Stop capability

Какво има в кутията

1бр. усилвател Helix P One MK2

1бр. инструкция

1бр. крепежни елементи